2026 Hyundai Translead Original® Base

Information

2026 Hyundai Translead Original®

The Hyundai Original® can be custom built to meet the specific needs of your operation. Versatile, durable and easy to service, the Original benefits from extensive automation in its computer-controlled build, for consistent, reliable quality.

Features may include:

  • Ultimate Corrosion Package

Offering additional protection to almost every steel components that are not part of the standard hot dipped galvanized package.

  • Aerodynamic Side Skirts

Aerodynamic side skirt options are available to meet US EPA SmartWay and California Air Resources Board requirements.

  • Roll-Up Doors

Roll-up doors are available from various manufacturers.

  • Dome Lamps

For increased interior visibility dome lamps are available from various manufacturers.

  • Rear Frame Options

Hyundai Translead can configure the rear of your trailer with features such as pintle hooks, side steps, and additional tail lights to meet your specific operational needs.

Photos

Highlights

  • Auburn, Washington
  • 2026
  • Hyundai Translead
  • Original® Base
  • Available
  • Exterior: 102.36' | Interior: 99' lining to lining
  • Exterior: 13´ 6' | Interior: 110'

Specifications

  • 2026
  • Hyundai Translead
  • Original®
  • Base
  • Dry Van
  • Exterior: 53´ 0' | Interior: 52´ 6'
  • Exterior: 102.36' | Interior: 99' lining to lining
  • Exterior: 13´ 6' | Interior: 110'
  • AIAG Rating: 18,000 lbs
  • 68,000 GVWR | 3950 cu. ft. of interior volume
  • Standard: 13,900 lbs
  • Rear Frame: Hot-dipped galvanized, high-tensile steel construction 0.19' thick with low profile header, tube shaped posts. Forged steel angle irons in top corners for added rack resistance. Lights recessed in rear sill with heavy-duty protection bars and welded reinforcing bar between tail lamps. | Side Sheets: Side sheets 0.05' thick pre-painted white aluminum. | Side Posts: Galvanized steel posts on 24' centers, 1.13' deep x 5' wide, with posts on 12' centers over coupler and landing gear area. | Front Wall: Four high-tensile, hat shaped, posts covered with 0.05' aluminum front sheets. | Interior Lining: Exterior grade plywood, 0.25' thick, installed horizontally over side posts. Exterior grade 0.5' plywood installed lower half of front wall and 0.25' over top height of front wall.
  • Composite swing door, 0.5' composite panel. Dual durometer seals bonded to door. Four hinges and one anti-rack locking bar with nylon bushings per door. Lock handles fitted with rubber grips for operator comfort and security.
  • One piece, .040" thick, full width aluminum sheet, tension leveled prior to installation | Roof Bows: Galvanized steel anti-snag hat section on 24" centers. Pre-bonded to roof sheet. Roof bows installed using four solid rivets, two per end.